| |
Chromatography Products
- Gas Purification systems
- HPLC mobile phase filter assembly
- SPE Vacuum Manifolds
- SPE cartridges 1mL to 6mL
- Syringes for GC & HPLC
- Vials for GC & HPLC
- HPLC Column
 |
 |
 |
 |
 |
| Autosampler Vials screw & crimp neck with 2mL, 1.5mL,
350uL and 250uL capacity in Clear & Amber glass |
| |
|
|
|
|
 |
 |
 |
 |
 |
| Various types of septa such as TEF/Rubber, Silicone
/PTFE is available |
 |
 |
 |
| Electronic crimper |
20mL, 40ml & 60mL EPA vials |
| |
|
|
 |
| 16mm Screw Thread Heapspace Vial, 22x46mm Clear 10mL |
| |
|
|
 |
| GC Syringe |
 |
 |
| The TC-20 tubing cutter is the only
CE marked motorized cutter for HPLC tubing currently available. |
A zero dead volume connection is important for maximum chromatographic
performance. Unswept volume, caused by a poor fit between tubing and the
mating seat, can cause sample dispersion and unsatisfactory chromatographic
results. Poor fit of the tubing can be due to a cut edge that is not square,
or by improper deburring. Burrs may prevent the tubing from fully seating
and may restrict the internal diameter.
Clean, square cuts:
The TC-20 tube cutter assures a zero dead volume connection. The tubing
is held securely in a clamp vice on the vertical swing arm. This swing
arm is then lowered against the abrasive cutting wheel, producing a perfectly
square cut. No lubricant or cutting fluid is required.
Cuts 3 common sizes of HPLC tubing:
1/16", 1/8" and 1/4" outside diameter (OD) tubing with
inside diameters as small as 0.008" can be smooth-cut and dressed
without distortion.
|
|
